I tried it out today (after trying to figure out the vacuum/suction part for 5-10 minutes) my Lighting Fast Carpet Solution on my carpets (not heavily stained), and just with the steam it took about 30-40 minutes for it to dry the carpet afterwards which is PHENOMENAL! I know that it can be used a steamer too, I will make sure to use the steamer on 3 cars this weekend for I can actually see the amazing power behind this. NOTE: Read full user manual for safety, maintenance, refilling, and best cleaning practices.įirst off, I just received it today, and I am still waiting on cart (Larry’s AMAZING customer service skills he said it wasn’t up to his standards, and will get me one ASAP).Īnyhow, I purchased this May 15/17th 2022, arrived today (due to FedEx Delay), and soon after I bought it Larry actually shot me an email thanking me for buying it, and letting me know the cart situation, and then actually called me (unfortunately I couldn’t answer I was at work), BUT the length this man will go to ensure good customer service. POWERING OFF After cleaning is completed, Push On/OFF bottom to turn off power to SeaHawk and unplug unit from power outlet. Push power button to restart your SeaHawk.ġ1. Turn off the SeaHawk and refill the water fill tank. REFILLING When your SeaHawk needs refilling, the RED low water light comes on and the Steamer will start beeping. C) The light on the handle turns ON during Extraction mode.ġ0. B) To activate, push and hold the extraction button on the hose handle. A) Fill extraction bottle with water and insert on back of the SeaHawk. Extraction When activated, the extraction feature sprays hot water along with steam for deep cleaning. (The vacuum can only be used on low to or medium setting while using the steam or extraction function).ĩ. B) To turn the vacuum "off" push the power button. A) To increase or decrease suction, push and HOLD the vacuum power button on the handle. Vacuum Press the vacuum button on the hose handle to activate. C) Turning the dial all the way to (-) is the lowest possible setting and no steam will release from the hose.Ĩ. B) Decrease steam pressure by turning the dial toward the (-) on the dial. A) Increase steam pressure by turning the dial board the (+) sign on the dial. Steam Control Dial controls the amount of steam released. When only steam is released from the hose, the system is ready for use.ħ. QUICK START Bleed the hose by pulling trigger on hose handler for 10 seconds to purge excess water from the hose. C) The Orange light may blink during operation indicating the boiler is heating.Ħ. B) Push power button to restart and resume heating. If the Red "Low Water" light comes on and steamer starts beeping: A) Turn off your SeaHawk and refill the water tank. ON/OFF Once the boiler reaches working pressure, the Orange light will go solid and the SeaHawk is ready for use. It will take 5 minutes for the SeaHawk to heat and be ready for use.ĥ. Use only a 12 gauge / 15AMP rated or higher extension cord. Plug into Electrical Outlet The Seahawk should be the only appliance plugged into the power outlet. Attach Hose Insert the vacuum hose with the release button on top.Ĥ. C) Add water to Hot Water Extraction Bottle and insert.ģ. B) Add water to fill mark of Vacuum Collection Tank. A) Lift lid of Steam Reservoir Tank and add water (tap water is okay).
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |